The machine is designed so that it can have enough stroke (approximately 150 mm ) and space for loading and easy operation; dimension  of hot plates is: 250*250mm with respect to molds. To have a uniform heat all through the plates, four heaters and a temperature sensor are installed in each plate with PID digital temperature controller, 0.1˚C accuracy. Since the machine applies pressure on the specimen under hot conditions, all plates are hard chrome plated to withstand heat and applied pressure and prevent corrosion. To apply uniform pressure on the materials, an advanced mechanism is installed under the lower plate to arrange them parallel to each other. A hydraulic system applies pressure on the specimen via the feedback from an accurate oil pressure sensor (tolerance ±100kg) and while attached to the hydraulic jack it can increase the applied load up to 50t on the plates. In this case, the loss of force that may occur during the test is automatically compensated. Cold plates have water-cooled system to produce quality sheets and prepare the machine for producing more sheets. Moreover, the machine has a strong chassis and four robust columns that create lower creep while reducing the load loss. The machine (380mm*520mm*700mm) can provide easy operation and installation on table or limited spaces.